Life Time Warranty By Kingston Malaysia What's in the box:- 1x Kingston RAM DDR4 CL19 SO-DIMM Notebook Memory DESCRIPTION :- This document describes ValueRAM's KVR26S19S6/4 as a 512M x 64-bit (4GB) DDR4-2666 CL19 SDRAM (Synchronous DRAM), 1Rx16, memory module, based on four 512M x 16-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR4-2666 timing of 19-19-19 at 1.2V. This 260-pin SODIMM uses gold contact fingers. The electrical and mechanical specifications are as follows: FEATURES :- • Power Supply: VDD = 1.2V Typical • VDDQ = 1.2V Typical • VPP = 2.5V Typical • VDDSPD = 2.2V to 3.6V • Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals • Low-power auto self refresh (LPASR) • Data bus inversion (DBI) for data bus • On-die VREFDQ generation and calibration • Single-rank • On-board I2 serial presence-detect (SPD) EEPROM • 8 internal banks; 2 groups of 4 banks each • Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS) • Selectable BC4 or BL8 on-the-fly (OTF) • Fly-by topology • Terminated control command and address bus • PCB: Height 1.18” (30.00mm) • RoHS Compliant and Halogen-Free SPECIFICATIONS :- CL(IDD) : 19 cycles Row Cycle Time (tRCmin) : 45.75ns(min.) Refresh to Active/Refresh : 350ns(min.) Command Time (tRFCmin) Row Active Time (tRASmin) : 32ns(min.) Maximum Operating Power : TBD W* UL Rating : 94 V - 0 Operating Temperature : 0o C to +85o C Storage Temperature : -55o C to +100o C *Power will vary depending on the SDRAM used